Inspire 1 with X5R Camera switching to AUTO.

[DragonflyCameraSupport]

Hello all,

We are experiencing a bug where the camera constantly resets to AUTO. Please see below for our configuration.

-Dual operator
-Camera settings settings typically set by slave controller (always set to Manual)
-Shooting 4k UHD / 24fps (although it seems to happen regardless of resolution and frame rate)
-Aircraft FW 1.9.1.30
-Camera FW 1.9.1.10
-Master RC FW 1.7.40
-DJI GO app 2.9.1 (3.0 is trash as far as I'm concerned)
-DJI focus with 5.8ghz wireless expansion module (works great BTW)
-Typically on radio channel 20
-FPVLR advanced antennas on both master and slave
-Prosight FPV system

We have noticed that the following things will prompt the camera to switch back to AUTO

-When changing battery
-When slave remote loses video signal for a moment
-When performing a lens calibration

Its quite an annoying bug, especially when I give the focus remote to the DP and give him iris control only to have to repeatedly explain why the f-stop needs to be constantly reset.

Does anyone have any workarounds to avoid this issue?