Hi folks - new member here. Actually found your group through trying to troubleshoot the above! I have now fixed it but thought I'd share what I found in case anyone else has the issue.
I swapped out the round GPS cover on my Inspire 2 today - it was just a bit scratched up and I thought I'd treat it to a fresh look - when I put everything back together, everything functioned just fine, but there were no front and rear LEDs and no status indicator - just a couple of purple flashes followed by another two on startup and then nothing.
Wondered at first if I'd messed a cable up taking the top shell off or putting it back on, but was really careful and only really opened it enough to undo the 6 screws holding the sat cover in place (if you do that change yourself, watch for the very thin o-ring!).
I couldn't find anything online so figured, seeing as there's no way to power the system with the shell off, that maybe reinitialising through DJI Assistant back to Factory Default would solve the problem (I tried reinstalling the firmware first - no joy)... and it did!
Anyway, I hope this thread finds someone having a similar issue and helps them out - would have saved me a good hour or so!
I swapped out the round GPS cover on my Inspire 2 today - it was just a bit scratched up and I thought I'd treat it to a fresh look - when I put everything back together, everything functioned just fine, but there were no front and rear LEDs and no status indicator - just a couple of purple flashes followed by another two on startup and then nothing.
Wondered at first if I'd messed a cable up taking the top shell off or putting it back on, but was really careful and only really opened it enough to undo the 6 screws holding the sat cover in place (if you do that change yourself, watch for the very thin o-ring!).
I couldn't find anything online so figured, seeing as there's no way to power the system with the shell off, that maybe reinitialising through DJI Assistant back to Factory Default would solve the problem (I tried reinstalling the firmware first - no joy)... and it did!
Anyway, I hope this thread finds someone having a similar issue and helps them out - would have saved me a good hour or so!
Last edited: