Hi Folks,
I'm really getting fed up, I stupidly updated my FW to 1.08 last month on one of my inspires, since them I've been having the dreaded signal loss issues and after rolling back the FW on the controller and the aircraft I could not get them to bind correctly, I had to re-install 1.08 to get it working again. I ended up grounding the aircraft as it's just not safe to fly like that.
Today I updated to 1.09 and it's even worse! After a short test flight out to 150m only I lost signal 3 times, once at my feet after landing!! This is ridiculous, it's unusable as it is.
Has anyone got any suggestions at all to improve the situation?
Luckily I have a backup inspire on an earlier FW that still works perfectly but I want to get this one back in the air too.
I'm really getting fed up, I stupidly updated my FW to 1.08 last month on one of my inspires, since them I've been having the dreaded signal loss issues and after rolling back the FW on the controller and the aircraft I could not get them to bind correctly, I had to re-install 1.08 to get it working again. I ended up grounding the aircraft as it's just not safe to fly like that.
Today I updated to 1.09 and it's even worse! After a short test flight out to 150m only I lost signal 3 times, once at my feet after landing!! This is ridiculous, it's unusable as it is.
Has anyone got any suggestions at all to improve the situation?
Luckily I have a backup inspire on an earlier FW that still works perfectly but I want to get this one back in the air too.