I got it assembled and did a couple test flights.. Since I was use to home built quads using my Taranis radio, I didn't do a lot of flying till I learn more about the DJI controller and how it flies. Will do some more today.. I flew it with both batteries installed but only one turned on, wanted to see how it handled.. It danced around a bit in hover and when it was flying straight, seemed to lose some altitude.. Wondering if I got the center of gravity correct.. both batteries are in the most rear position and the x3 out front. There was almost a complete lack of documentation that came with it. lots of Chinese though! nothing that told you how to assemble so I went based on some YT video's I found. DJI did not provide any adhesive for putting the GPS mast together but I had some thick CA handy.. It did come with a bunch of 2 sided tape for mounting the GPS and the small silver box (looks like an external connection port?
They should have left the battery compartment off when packed in the box because you have to remove it to get at the antenna connections anyway.