- Joined
- Jan 14, 2016
- Messages
- 38
- Reaction score
- 0
- Age
- 53
Hello all,
I just picked up a new osmo with the X3 camera. Plan was to swap the stock X3 lens for a NDVI lens in the X3.
I currently have the inspire pro with a X5. I just put the X3 camera on the inspire 1 pro and booted up for test. Everything on the inspire 1 is up to date. Upon booting up the inspire the X3 camera doesn't do its gimbal roll, gimbal status says ok however. It did say I need to update camera firmware. I tried to to a gimbal calibration as well but gimbal doesn't move for some reason. Is this a firmware issue? Should the X3 get its firmware automatically from the inspire?
update:
Nevermind it appears OSMO camera only works with OSMO and not with Inspire. They could of designed it to work on both but of course not. Will just send it back...
I just picked up a new osmo with the X3 camera. Plan was to swap the stock X3 lens for a NDVI lens in the X3.
I currently have the inspire pro with a X5. I just put the X3 camera on the inspire 1 pro and booted up for test. Everything on the inspire 1 is up to date. Upon booting up the inspire the X3 camera doesn't do its gimbal roll, gimbal status says ok however. It did say I need to update camera firmware. I tried to to a gimbal calibration as well but gimbal doesn't move for some reason. Is this a firmware issue? Should the X3 get its firmware automatically from the inspire?
update:
Nevermind it appears OSMO camera only works with OSMO and not with Inspire. They could of designed it to work on both but of course not. Will just send it back...
Last edited: