I'm having an issue with my Cendence controller. In Master mode the aircraft will only move forward, backward, or sideways up to 4 mph. I've tried re-calibrating. The sticks each go to 100%. Only one gimbal dial is responsive to calibration. The bottom pitch dials aren't responsive to calibration either. I've checked all of the modes / settings I can find. It's almost like it's stuck in "Tripod" or beginner mode, but it's not in those modes. When I use the Cendence as a slave it works properly. The standard controller also works fine with no issues. Ideas?
Florida Drone Supply
Approved Vendor
You have probably already checked this but do you have the side slider dials enabled to anything or undefined?
The sliders on the bottom sides are undefined. Reading some of the other threads I gather they’re not enabled. I’m really just concerned with the control sticks not moving the drone more than a few mph
Sooooo... looking at your tip I took another look at my side dial settings. Behold in Master mode the right dial was set to “Exp & Gain sensitivity”. Problem fixed! It’s now flying appropriately. Rookie mistake but thanks for the help!
Florida Drone Supply
Approved Vendor
Similar threads
