Copper flex pin snapped.Do I have to replace my entire vibration board on my X5R?

[TayWey]

After my last Drone operation. I was putting everything away and managed to snap a copper flex pin on my Inspire 1 where the X5R gimbal system connects to the aircraft body. Does anyone know the best way to get this fixed? Do I have to buy an entire new vibration board or is there a way to just replace the pins? I should mention I live in Canada.
Sorry for the horrible iPhone photos, but I’m sure you get the idea of the part I am referring to..

 

[The Editor]

After my last Drone operation. I was putting everything away and managed to snap a copper flex pin on my Inspire 1 where the X5R gimbal system connects to the aircraft body. Does anyone know the best way to get this fixed? Do I have to buy an entire new vibration board or is there a way to just replace the pins? I should mention I live in Canada.
Sorry for the horrible iPhone photos, but I’m sure you get the idea of the part I am referring to.. View attachment 24640View attachment 24641

Moved to Inspire 1 help section

Yes, you need to replace the entire assembly unless you can source just the connecting board via FleaBay or similar- Probably not worth it as any part like that will be second hand. Whole mounting assembly ready available, cheap and easy fix.

 

[jaycmc]

It’s just a replacement gimbal port you need. Around $30 usd from flea bay new. Lowest is $25 right now when I checked.

 

[MrTVR]

I think this is probably the part you require ...

Inspire 1 Fast-Mounting Gimbal Port PCBA - Heliguy

I replaced this part on my I1 when I started to get intermittent issues with the video feed. An easy fix and it cured the problem.