Hi all, just a precursor, i am in Aust., so for gimbal supply local is preferred, though not restricted.
Ok... I have recently purchased an I1v2(Pro) and also picked up a V1 package for some accessories etc and was going to sell the AC & Tx's. Since i also had a recent hard landing and now needing parts, i am thinking of keeping it as a back-up, and got to wondering about Tx's.
Is it at all possible to bind two different AC to the Main Tx in case one is down for whatever reason? Second, if that doesn't work, would it be possible to bind the Co-Pilot Tx with a second craft, and use it as the Primary Tx when required?
I am used to sources like JR, Spektrum, Futaba etc where one Tx may have many AC profiles, and not used to this closed system, or it's limits.
I hope i have asked that coherently for an answer.
Secondly, I have a broken gimbal arm on my Z3 and was wondering where i may be able to source one, as i don't see them listed on any DJI reseller sites or DJI itself.
All responses appreciated.
A.U.S.
Ok... I have recently purchased an I1v2(Pro) and also picked up a V1 package for some accessories etc and was going to sell the AC & Tx's. Since i also had a recent hard landing and now needing parts, i am thinking of keeping it as a back-up, and got to wondering about Tx's.
Is it at all possible to bind two different AC to the Main Tx in case one is down for whatever reason? Second, if that doesn't work, would it be possible to bind the Co-Pilot Tx with a second craft, and use it as the Primary Tx when required?
I am used to sources like JR, Spektrum, Futaba etc where one Tx may have many AC profiles, and not used to this closed system, or it's limits.
I hope i have asked that coherently for an answer.
Secondly, I have a broken gimbal arm on my Z3 and was wondering where i may be able to source one, as i don't see them listed on any DJI reseller sites or DJI itself.
All responses appreciated.
A.U.S.
