IMU problem after firmware update SOLVED

Juan Crane

Joined
Jun 19, 2015
Messages
34
Reaction score
17
Age
50
Ok, here's the story, I installed the firmware on the I1, report on the micro sd card reported success, then installed the firmware on the master radio and there was an issue, micro sd card reported corrupted file, so I downloaded the file again and reinstalled firmware on the radio, this time the card reported success. So I updated batts and figured I was good to go, tried recalibrating the IMU but always get an error at 94%.
I am thinking the initial firmware was corrupt and even though I got a success message it did not install correctly in the aircraft, how can I reinstall or should I install previouse firmware and then update again???
Help!
 

I updated mine tonight, no issues. You mentioned corrupt file on the SD card. I updated the RC using the bin file on a USB drive. Did you use the cable from the gimbal? I wonder if that's the reason.
 
Sounds like your inspire took the firmware update. .
make sure and calibrate your imu when the ac is cold on a completely flat surface ..
 
Reactions: Aviator
Alastair said:
I updated mine tonight, no issues. You mentioned corrupt file on the SD card. I updated the RC using the bin file on a USB drive. Did you use the cable from the gimbal? I wonder if that's the reason.
Click to expand...
Yes I used a USB drive for the radio.
 
turbodronepilot said:
Sounds like your inspire took the firmware update. .
make sure and calibrate your imu when the ac is cold on a completely flat surface ..
Click to expand...
It was cold and sitting over the flattest surface I could find.
I tried 10 different times over different surfaces and different places. Always let it cool down for at least 20 minutes.
 
Last edited:
Reactions: turbodronepilot
The missing blade generates vibration which results in an IMU calibration error
 

Attachments

  • 20150807_100650.jpg
    3.6 MB · Views: 94
Reactions: turbodronepilot
You must log in or register to reply here.

Similar threads

T
Inspire 1 Pro X5 with “No Image Transmission Signal”
Replies
1
Views
872
Inspire 1 Discussion
0spikey
0
Inspire 1 Pro Very Poor Range after Firmware update???
Replies
7
Views
3K
Inspire 1 Discussion
Donnie Frank
A
updated Inspire 2 - Canada
Replies
2
Views
827
Classifieds
Aerialworks
A
G
Problem reading the micro sd card. Help!
Replies
19
Views
4K
Zenmuse X5R
lynn45
L
NBD (new bird day!)
Replies
6
Views
1K
General Discussion
Niner six echo
Menu
Log in
Register