I know there have been several threads about this already and I apologize if I'm beating a dead horse but most of those I've seen were almost two years old. The master controller has almost perfect video the entire time even while the slave is either seeing a green screen, frozen video, half screen video, and loss of gimbal control. I read several posts that said it was a firmware issue in the past and should be corrected but I'm not seeing a great deal of resulution to this seemingly widespread problem. Our firmware is up to date and I'm not sure where to go next. Any help would be greatly appreciated. Thanks in advance.
Inspire 1 Slave Controller video loss and interference
- Thread starter asand211
- Start date
Similar threads
