vision positioning cable

[Beverly Hills Aerials]

anyone know what the cable is called that connects to the vision positioning? i need to replace just the cable. thank you.

 

[Beverly Hills Aerials]

or anyone know what the end pieces are called i could just reattach a new piece... just cant find them online...

trying to figure out what the cable end piece is called for the 5pin visioning positining cable and the 6 pin tail light cable.

anyone ?

 

[The Editor]

or anyone know what the end pieces are called i could just reattach a new piece... just cant find them online...

trying to figure out what the cable end piece is called for the 5pin visioning positining cable and the 6 pin tail light cable.

anyone ?

Can you post a photo?
It's probably a Molex since nearly all the plugs/sockets on the I1 are but post up a pic and I or someone should be able to tell you.

 

[Beverly Hills Aerials]

See attached photo of taillight cable

 

[The Editor]

See attached photo of taillight cable

Here ya go.... (you will need to match the number of conductors that you have on your existing cable, then find a local/internet stockiest)
Wire-to-Board Connectors - Molex