Buzzing, landing gear, camera no pic

D

DrSeuss

Joined
Jun 8, 2015
Messages
14
Reaction score
1
Age
52
I
Hey everybody. I have an emergency. I am on a shoot with several issues.
1. No video image from camera is being displayed on iPads.
2. LOUD buzzing noise in cone.
3. Landing gear will not lower or raise. Landing gear is stuck in Landing mode and will not raise for flight. Also, I can tell I1 to go to travel mode and blue tail light will be active, but landing gear will not be lowered for travel mode.







Any ideas how to solve issues while on production location?
 

Attachments

  • 20171208_124306.jpg
    3.6 MB · Views: 15
Last edited:
Sounds like an issue with the worm gear. Can you manually try to turn it? It might just be stuck in place and can be freed with a bit of a twist.
 
DrSeuss said:
Is the FC the Ncore component? The fan on it spins freely and the I1 can take off for flight with movements, but the arms do not lower or raise.

DJI Inspire 1 Ncore component
Click to expand...
Yes that would be it. Has several names from being called lightbridge, N core, flight controller and a few other. Pull the plastics off .Take the 3 screws out of the black wire cover on the right hand side and remove it and unplug the servo motor for the landing gear. It’ll be the black plug with the gray,brown,and black wires and see if it stops buzzing. If it doesn’t problem is either the power board or the fc. Does it do it with any battery you use or is it happening with just one or two batteries?
 
You must log in or register to reply here.

Similar threads

E
Inspire 1 landing gear issues
Replies
4
Views
2K
Inspire 1 Help
emil2rs1
E
T
Inspire 1 Pro X5 with “No Image Transmission Signal”
Replies
1
Views
862
Inspire 1 Discussion
0spikey
0
R
Inspire 1 landing gear
Replies
6
Views
3K
Inspire 1 Help
drone_prof
D
U
Inspire 1 landing gear not responding
Replies
7
Views
5K
Inspire 1 Help
Sideshow
G
Camera sensor error / remove gimbal and exit travel mode.
Replies
1
Views
3K
Zenmuse X5S
Tenyouken
T
Menu
Log in
Register