Dji DT7 + DR16

[ricardo_spk]

hi I wanted to know if some guru can explain me what this connection?

https://s21.postimg.org/uy1fauzuf/Full_Size_Render.jpg

I already read about changing the antena for better signal, but when I opened the DT7 it has a free connector, and I wanted to know if it works for installing two more selection buttons.

Tank you very much.
Waiting for news in Portugal heheheh.

 

[The Editor]

hi I wanted to know if some guru can explain me what this connection?

https://s21.postimg.org/uy1fauzuf/Full_Size_Render.jpg

I already read about changing the antena for better signal, but when I opened the DT7 it has a free connector, and I wanted to know if it works for installing two more selection buttons.

Tank you very much.
Waiting for news in Portugal heheheh.

Even if that were the case, the firmware would not map the buttons.

 

[ricardo_spk]

Tank you for fast feedback. Bad luck then I was thinking to use this controller from my phantom with my 3D printed inspire version , but no luck to link a button to the retraction arms... heheh tanks again.


Sent from my iPhone using InspirePilots