i go to the DJI site inspire 1 and it lists firmware for x3 and another for x3 then a how to on 1.4 and a 1.3 that i think i already have where is the file for 1.4
i go to the DJI site inspire 1 and it lists firmware for x3 and another for x3 then a how to on 1.4 and a 1.3 that i think i already have where is the file for 1.4
Keep an eye on the DJI downloads page for the most recent, downloads and information. There are different firmwares for different pieces of hardware.what is the exact #s for the new firmware
what are the exact #s for the updated firmware for an Inspire 1 with standard camera
As requested by many, MANY of you, here are the proper directions to upgrade your firmware. These directions come directly from a well respected member of the DJI community as well as our little slice here on the forum.
"It's a very simple process. You want to load the bin file on the root of the sd card ( x:\filename.bin). I advise to ONLY power the craft and let the upgrade process start, once done you will hear a change of the beeps. The completion tone is DA (pause)... DA, DA. Once the craft is updated power down and do the TX. I use a freshly formatted USB thumb drive for the TX. Copy the same bin file to the thumb drive (x:\filename.bin). The upgrade should start after about 30sec. Once complete the TX light will turn from blue to green, upgrade complete.
I advise users to keep the bin file on the card. This allows all batteries inserted to be upgraded IF required."
Thanks Blade.
Yes, got it taken of. Just upgraded FW for X3 1.10.01.40. Solved, and can switch back and forth between X3 and X5 w/o issues. Thanks.I hope someone else here can help you. I still use my original inspire with the original camera. I've upgraded firmware like 3 times.
As requested by many, MANY of you, here are the proper directions to upgrade your firmware. These directions come directly from a well respected member of the DJI community as well as our little slice here on the forum.
"It's a very simple process. You want to load the bin file on the root of the sd card ( x:\filename.bin). I advise to ONLY power the craft and let the upgrade process start, once done you will hear a change of the beeps. The completion tone is DA (pause)... DA, DA. Once the craft is updated power down and do the TX. I use a freshly formatted USB thumb drive for the TX. Copy the same bin file to the thumb drive (x:\filename.bin). The upgrade should start after about 30sec. Once complete the TX light will turn from blue to green, upgrade complete.
I advise users to keep the bin file on the card. This allows all batteries inserted to be upgraded IF required."
Thanks Blade.
Luis,Same old story, updated to Inspire 1 Pro Firmware v1.11.1.50, now can't get an image transmission signal using X5. My X3 works fine.
Aircraft Firmware v1.11.1.50
RC- 1.7.80
Any suggestions?
That sounds like a bad board to me. I hope its an inexpensive fix.Thanks, Randal. The X3 stopped connecting too, so now it's at Innovative UAS (DJI dealer, only 40 mins away....)
Or asked this question on a separate thread here.Can I put the x5s and put it on an inspire 1 v2? And how
Thanks. Found 1.11.1.50 on the DJI website.@licensed pilot the last firmware update for the Inspire 1 (1.11.1.50 ) was issued in Oct 2017. The DJI Go app has received further updates via the various app stores.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?