Inspire 1 IMU initalization Failed, Barometer Error

[Matox]

Hello, I have Inspire 1 and it started to do these errors IMU initalization Failed, Barometer Error. Also if camera (x5) is connected this error comes too Gimbal cannot recieve Main Controller data. Camera works other inspire well. IMU wont calibrated, if I try it it try calibrated it goes normal 100%, but when it finish it it only stay red calibrated. After restart it says same errors again. If I try Check IMU, it says no need to calibrate IMU.

Firmware 1.11.1.50

RC: 1.7.80

Is here someone who did have same problem and repaired changing new IMU?

 

[Linuxglobal]

was the bird involved in a crash ?? how did these issue come up ?

You can try a very level surface, and re-calibrate IMU. Avoid close contact to metal objects etc.