100% a motor overload... I deal with servos at work, there's a gain setting in the programming gone awry....I'm not going to fly mine until it's fixed. There no point, plus I don't want to do any damage to camera or Inspire . The head seems to be heating up more than I ever noticed before. Probaly motor overload or something.
I dont care about speed too much myself. My best filming is done on Tripod mode.
Mine did the same exact thing! not the flying, but stopped at 85%What is it braking and I noticed the throttle isn't as responsive as it was before mine one download with the remote on I had to shut it off I think they just put too much stuff on one firmware it went to 85% and stopped I unplugged it after about 15 minutes plugged it back in and had to cancel it and refresh with the remote off
It was aggravating an not knowing if it downloaded correctly. Everything seems to work OK on the ground haven't had a chance to fly itMine did the same exact thing!
The app said to unplug and plug in directly to USB on craftYou guys should have waited... it eventually goes through...
Mine wouldn't till I unplugged it an turned the remote off . Had to reset the assistant app tooYou guys should have waited... it eventually goes through...
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?