I am looking for information as to how to raise/ lower the Inspire landing gear from the DJI GO app.
I have done this procedure before, but cant seem to find the correct screen to do this.
use the switch on the RC you flip it up or down to raise and lower the landing gear while flying. then when landed with camera removed you go up and down 4-5 times rather quick to enter or exit travel mode
I recently purchased an I1 v2 with very low hours. When I use the switch 4 times on the controller, the landing gear goes into travel mode, but too far. What I mean it that the bottom of the drone bottoms out on the ground and the legs go about two inches further than they should. If I do the same process but lift up on the top of the drone to take some of the weight off the legs, it stops in the correct "Travel" position??
I recently purchased an I1 v2 with very low hours. When I use the switch 4 times on the controller, the landing gear goes into travel mode, but too far. What I mean it that the bottom of the drone bottoms out on the ground and the legs go about two inches further than they should. If I do the same process but lift up on the top of the drone to take some of the weight off the legs, it stops in the correct "Travel" position??
it depends on the surface sometimes. carpet is bad. the stock case lid, dull tile floor, or place a piece of paper under it. it seems too shiny and carpet mess with the VPS sensor
it depends on the surface sometimes. carpet is bad. the stock case lid, dull tile floor, or place a piece of paper under it. it seems too shiny and carpet mess with the VPS sensor