DJI GO App Landing Gear Function

[HRO]

I am looking for information as to how to raise/ lower the Inspire landing gear from the DJI GO app.
I have done this procedure before, but cant seem to find the correct screen to do this.

 

[fofun]

Go into the main controller settings, then advanced settings and it’s towards the bottom.

 

[HRO]

This menu only lets you turn the automatic landing feature on or off, it wont let you raise or lower the landing gear.

 

[Chipdji]

 

[HRO]

Got it. eyes not as good as they used to be.
Thanks

 

[TruGreen]

use the switch on the RC you flip it up or down to raise and lower the landing gear while flying. then when landed with camera removed you go up and down 4-5 times rather quick to enter or exit travel mode

 

[jkerrins]

I recently purchased an I1 v2 with very low hours. When I use the switch 4 times on the controller, the landing gear goes into travel mode, but too far. What I mean it that the bottom of the drone bottoms out on the ground and the legs go about two inches further than they should. If I do the same process but lift up on the top of the drone to take some of the weight off the legs, it stops in the correct "Travel" position??

 

[TruGreen]

I recently purchased an I1 v2 with very low hours. When I use the switch 4 times on the controller, the landing gear goes into travel mode, but too far. What I mean it that the bottom of the drone bottoms out on the ground and the legs go about two inches further than they should. If I do the same process but lift up on the top of the drone to take some of the weight off the legs, it stops in the correct "Travel" position??

it depends on the surface sometimes. carpet is bad. the stock case lid, dull tile floor, or place a piece of paper under it. it seems too shiny and carpet mess with the VPS sensor

 

[jkerrins]

it depends on the surface sometimes. carpet is bad. the stock case lid, dull tile floor, or place a piece of paper under it. it seems too shiny and carpet mess with the VPS sensor

You nailed it! I was using a 3x3 carpet square for a landing pad. As soon as I got rid of the, problem solved.

Much Appreciate

 

[TruGreen]

You nailed it! I was using a 3x3 carpet square for a landing pad. As soon as I got rid of the, problem solved.

Much Appreciate

yea the carpet absorbs the sonar. if you video the drone with a phone you will hear it on playback as a bunch of clicks