Mounting plate screw

[Labphoto]

Got some new Xoar Carbon Fiber Props for Christmas and was going to mount them today. I went to remove the stock plates and the 2nd screw is stripped. Any ideas on how to remove it?

 

[The Editor]

Got some new Xoar Carbon Fiber Props for Christmas and was going to mount them today. I went to remove the stock plates and the 2nd screw is stripped. Any ideas on how to remove it?

Maybe try a search......
Stucked Allen screw of center frame, anyone encountered this before? Any suggestion?
Inspire 2 Motor - Screw Dimensions
smh... Stripped a nut on motor

 

[Chipdji]

Putting a little heat on it will usually work. Just take your time. I have been running them props for quite a while you will love them.

 

[Labphoto]

Tried everything, heat gun, soldering iron, etc. taking it to DJI Arizona for them to deal with it. Thanks to everyone for their suggestions.

 

[Phil DeVore]

Tried everything, heat gun, soldering iron, etc. taking it to DJI Arizona for them to deal with it. Thanks to everyone for their suggestions.

That sounds like the best idea at this point. Stripped screws aren’t easily removed. Sounds like somebody else tried removing the screw before and stripped it and then just gave up and left it for the next person to deal with. Did you purchase it used?
Good luck with it.

 

[Arturo]

It's a nightmare, I will try soldering iron this night, I broke 3 torx on it (amazon brand, husky and milwaukee)