Configuring slave remote settings

[Ascender]

Could use some pointers here on setting gimbal controls up for second controller.

How can yaw and Atti be adjusted for the second remote? How about tilt gimbal wheel speed? I think they're under advanced settings but I can't seem to access Mode from the slave controller.

Any suggestions on C1/C2 config for slave?

Lastly- for either remote- where is the pan stick exp curve and yaw exp curve setting?

Thanks in advance!

 

[Kilrah]

It's in the "radio" icon -> Mode. There's no expo for camera control at this point but you can set the sensitivity.

 

[Ascender]

It's in the "radio" icon -> Mode. There's no expo for camera control at this point but you can set the sensitivity.

Thanks, Kilrah!

By the way, I always learn a lot from your posts. It's evident that you know your stuff, and I'm appreciative of you sharing your knowledge.