Log out of your GO app after upgrade, then shut everything down. Start the master controller first, followed by the aircraft followed by the GO app. Log back into the GO app and you will not have any problems with flight parameter limitations. I have not experienced any problems with my I1v2 as far as firmware. You just have to do your reading before you begin rather than in the middle of an upgrade. Saves a lot of trouble....Thank you for the advice about the Image Transmission Code Rate, I didn't use and set this feature because I wasn't sure about what is use for.
You said that the last aircraft firmware works fine with android, so what's happend when the tablet isn't connected to the internet (wifi switch off or no network) ? Nothing about restrictions ?
I'm sorry to insist about this but I'm a quite afraid by this kind of restrictions issue if it's occur during a job !!